Material Safety Data Sheet
K-GRIP 406
Maple Leaf Sales II, inc.
Middleville, Michigan
Emergency Number: 1-800-424-9300
(Chemtrec)
MLS Number: MLS 660801B
MSDS Revision Date:
Section 1 – Product Identification
K-GRIP 406 Landau
Top & Trim Spray Adhesive (Flammable)
Section 2 – Composition, Information on Ingredients
|
1.
Acetone CAS#
67-64-1 15 – 40% TSCA – Y 2.
Light Aliphatic Naphtha CAS#
64742-89-8 10 – 30% TSCA – Y 3.
Toluene CAS#
108-88-3 7 – 13% TSCA – Y |
4.
Hexane CAS#
110-54-3 5 – 10% TSCA – Y 5.
Cyclohexane CAS#
110-82-7 1 – 5% TSCA – Y |
HMIS Information:
Health: 2, Flammability: 3, Reactivity: 0, PPI: B
Hazard
Rating: 0 – Minimal 1 – Slight 2 – Moderate 3 – High 4 – Extreme * – Chronic
Section 3 – Physical and Chemical
Properties
Appearance
/ Color: Clear
Boiling
Range: 0° F – 315° F
Evaporation
Rate: Faster than n-Butyl Acetate
% Volatile
Weight: 83.09%
% Volatile
Volume: Not Available
Specific
Gravity: 0.795
Weight /
Volume Measure: 6.6435
Max. VOC:
609.6 Gal. /L.
Section 4 – Fire and Explosion Hazard
Danger
Flammability Class: IB
Extinguishing Media:
Foam, dry chemical, carbon dioxide, water spray or fog
Special Firefighting Procedures:
Avoid breathing smoke.
Use air supplied rescue equipment for enclosed area. Water tends to spread burning liquid (if
large amounts used).
Unusual Fire & Explosion Hazards:
Vapors are heavier than air and may travel to an ignition
source distant from the material handling point.
Section 5 – Health Hazard Data
Permissible Exposure Level:
See section 8.
Effects of Overexposure:
Ingestion:
Can cause gastrointestinal irritation, nausea and
vomiting. Aspiration of material into
lungs may cause chemical pneumonitis which can be fatal.
Inhalation:
May cause nose or throat irritation. High concentrations may cause acute central
nervous system depression characterized by headaches, dizziness, nausea and
confusion.
Eyes:
May cause severe eye irritation and corneal damage.
Skin:
May cause dermatitis.
May cause defatting and irritation of the skin.
First Aid:
Eyes:
Flush with large amounts of water, lifting upper and lower
lids occasionally. Get medical
attention.
Skin:
Thoroughly wash exposed area with soap and water. Remove contaminated clothing and launder
before reuse.
Ingestion:
Do not induce vomiting; keep person warm, quiet, and get
medical attention. (Aspiration of this
material into the lungs due to vomiting can cause chemical pneumonitis which
can be fatal.)
Inhalation:
Remove individual to fresh air and if breathing is
difficult, administer oxygen.
Section 6 – Reactivity Data
Stability:
This product is stable
Hazardous Polymerization:
Hazardous polymerization will not occur
Incompatibility:
Strong oxidizing agents, strong acids and bases
Conditions to Avoid:
Fire, sparks, static electricity
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide
Section 7 – Spill or Leak Procedures
Steps to be Taken in Case Material is Released or Spilled:
Keep spectators away.
Eliminate all ignition sources (flames, hot surfaces and sources of
electrical, static or frictional sparks).
Dike and contain spill with inert material (e.g. sand, earth). Transfer liquids to covered metal containers
for recovery or disposal, or remove with inert absorbent. Use only non-sparking tools. Place absorbent diking materials in covered
metal containers for disposal. Prevent
contamination of sewers, streams and ground water with spilled material or used
absorbent.
Waste Disposal Method:
Dispose of in accordance with local, state and federal
regulations.
Section 8 – Exposure Controls, Personal
Protection
Occupational Exposure Limits:
|
Acetone: ACGIH-TLV: 500 ppm ACGIH-TLV-C: Not Established ACGIH-STEL: 750 ppm OSHA-STEL: Not Established OSHA-PEL: 1000 ppm Light Aliphatic Naphtha: ACGIH-TLV: 100 ppm ACGIH-TLV-C: Not Established ACGIH-STEL: Not Established OSHA-STEL: Not Established OSHA-PEL: 500 ppm |
Toluene: ACGIH-TLV: 50 ppm ACGIH-TLV-C: Not Established ACGIH-STEL: Not Established OSHA-STEL: Not Established OSHA-PEL: 200 ppm Hexane: ACGIH-TLV: 400 ppm ACGIH-TLV-C: Not Established ACGIH-STEL: 500 ppm OSHA-STEL: Not Established OSHA-PEL: 500 ppm |
Cyclohexane: ACGIH-TLV: 200 ppm ACGIH-TLV-C: Not Established ACGIH-STEL: Not Established OSHA-STEL: Not Established OSHA-PEL: 200 ppm |
Respiratory
Protection:
If
workplace exposure limit of product is exceeded, a NIOSH/MSHA approved air
supplied respirator is advised in absence of proper environmental control. Engineering or administrative controls
should be implemented to reduce exposure.
Ventilation:
Provide
sufficient mechanical (general and/or local exhaust) ventilation to maintain
exposure below PEL.
Protective
Gloves:
Chemical
resistant gloves
Eye
Protection:
Chemical
splash goggles in compliance with OSHA regulations are advised.
Other
Protective Equipment:
To prevent
repeated, prolonged skin contact, wear impervious clothing and boots.
Section 9 – Special Precautions
Precautions
to be Taken in Handling and Storage:
Keep
container closed when not in use. Store
at 60 – 95° F and out of the sun. Use
adequate ventilation to avoid breathing vapors when cover is removed. Ground all equipment when handling flammable
solvent borne materials.
Other
Precautions:
Containers
may be hazardous when empty. Never use
welding or cutting torch on or near drum (even when empty).
Section 10 – Additional Regulatory
Information
SARA Title III Section 313:
This product contains the following toxic chemicals subject
to the reporting requirements of Section 313 of the Emergency Planning and
Community Right to Know Act of 1986 and of 40 CFR 372:
Toluene (CAS# 108-88-3): 7 – 13%
Hexane (CAS# 110-54-3): 5 – 10%
Cyclohexane (CAS# 110-82-7): 1 – 5%
Prop 65 (Teratogen)
Warning: This product contains a chemical known to the State
of
Toluene (CAS# 108-88-3): 7 – 13%
The following ingredients are registered for TSCA 12B:
Acetone (CAS# 67-64-1): 15 – 40%
Hexane (CAS# 110-54-3): 5 – 10%
Cyclohexane (CAS# 110-82-7): 1 – 5%
Section 11 – Other Information
Disclaimer of Warranty and Other Comments:
The information contained herein is, to the best of our
knowledge and belief, accurate.
However, because the conditions of handling and use are beyond our
control, we make no guarantee of results, and assume no liability for damages
incurred by the use of this material.
It is the responsibility of the user to comply with all federal, state,
and local laws and regulations.
The responsibility to provide a safe workplace remains with
the user. The user should consider the
health hazards and safety information contained herein as a guide and should
take those precautions required in an individual operation to instruct
employees and to develop work practice procedures for a safe work environment.
Abbreviations:
|
ACGIH: American Conference of Governmental &
Industrial Hygienists. OSHA: Occupational Safety & Health Administration NIOSH: National Institute for Occupational Safety and
Health IARC: International Agency for Research on Cancer NTP: National Toxicology Program TLV: Threshold Limit Value (ACGIH) PEL: Permissible Exposure Limit (OSHA) |
TWA: Time Weighted Average STEL: Short Term Exposure Limit ppm:
parts per million mg/cum:
milligrams per cubic meter of air N/D: Not
Determined N/A: Not
Applicable HMIS: Hazardous Materials Identification System |